Craftsman 172.11702 Operator's Manual page 17

ASSEMBLY cont.
TO REMOVE AND EMPTY DUST BAG cont. (See Fig. 6)
3. Remove the dust bag / wire adapter from the dust bag assembly by sliding it down
and out of the slots in the assembly (see Fig. 6a).
4. Remove the bag from the wire frame and shake aggressively to completely empty the bag.
(see Fig. 6b)
Fig 6
Fig 6a
5. When the bag is empty attach bag back onto the wire frame adapter (see Fig. 6b).
Make sure the bag is fastened up to, and tightly around, the adapter.
6. Slide dust bag / wire adapter up into the slots on the dust bag assembly (see Fig. 6a)
until they snap into position.
7. Attach dust bag assembly back into the sander.
8. Your sander is now ready to use.
NOTE: Empty dust bag frequently when sanding so dust collection system
works properly
Dust Adapter
Exhaust Hole
Fig 6b
17
Dust Bag
Assembly
Dust Bag