Assembly - Craftsman 172.11702 Operator's Manual

DESCRIPTION cont.
PRODUCT SPECIFICATIONS
No-load Speed
Rating
Input
Orbit Diameter
Paper Size
Paper Type

ASSEMBLY

WARNING:
!
when you are assembling parts, making adjustments, installing or removing
sandpaper, cleaning or when it is not in use. Disconnecting the sander will prevent
accidental starting, that could cause serious personal injury.
INSTALLING THE SANDPAPER (See Figs. 3, 3a, 3b and 4)
This sander has a cushion that allows you to use either non-adhesive sandpaper or
pressure sensitive adhesive-backed sandpaper. The non-adhesive sandpaper clamps to
the front and back of the platen and cushion. Adhesive backed sandpaper is applied
directly onto the cushion.
This sander has a dust collection system that collects dust from the worksurface through
10 holes located in the platen and cushion on the bottom of the sander. A paper punch
template is included for accurately punching holes into the 1/3-sheet sandpaper.
NOTE: Holes must be punched into the paper for the dust collection system to
work properly. See instructions on page 15 to punch holes.
Installing Non-Adhesive Sandpaper (See Figs. 3, 3a and 3b)
Fig 3
Paper
Clamp
Paper
Goes
Under
Clamp
Platen
12,000 OPM (Orbits Per Minute)
120 Volts, 60 Hz AC
2.0 Amps
1/16 in.
1/3 Sheet
Non-Adhesive Sandpaper and Adhesive Sandpaper
Your sander should NEVER be connected to the power source
Non-Adhesive
Sandpaper
Paper Goes
Under Clamp
Paper
Clamp
Platen
Lever
Slot
Paper
Clamp
Cushion
13