Nylon Line Disassembly; Nylon Line Replacement - Echo SRM-266T Operator's Manual

nylon lIne dIsassembly InstructIons
NOTE
For normal use, Speed Feed head disassembly is not necessary.
However, if circumstances require disassembly, follow these
instructions.
1. Press top of locking tabs (A) on both sides of Speed Feed head to
release cover (B) from eyelet carrier(C).
2. Remove cover from eyelet carrier.

nylon lIne replacement

1. Cut one piece of line to recommended length.
.080 (2.0 mm) dia. – 20' (6 m)
.095 (2.4 mm) dia. – 20' (6 m)
2. Align arrows on top of knob with openings in eyelets.
3. Insert one end of trimmer line into an eyelet, and push line equal
distance through trimmer head.
4. Hold trimmer head while turning knob clockwise to wind line onto
spool until about 5" (13 cm) of each line remains exposed.
Trimmer head is now fully loaded and ready for operation.
IMPORTANT
When the wear indicators located at the bottom of the Speed-Feed
head are worn smooth, replacement of the cover or the entire
Speed-Feed head is required.
G T
rass rimmer
O
peratOr
Wear
Indicators
/B C
rush uTTer
' M
s anual
C
A
B
Wear
Indicators
25