Echo SRM-266T Operator's Manual page 12

12
operatIon wIth blades
Preparing the Trimmer/Brush Cutter for Blade Use
WARNING
Blade use DEMANDS specific Brush Cutter configuration. Operation without specified shield, barrier bar or U-
handle, and harness can result in serious personal injury. Follow installation instructions included in optional kits.
TO USE
THESE BLADES
You
must
install
these
parts!
• WARNING! DO NOT INSTALL BLADES ON GT (CURVED SHAFT) MODEL TRIMMERS
• Arbor diameter of Upper Blade Plate must match arbor diameter of blades.
• New cotter pin required each time blade is installed.
• Brush Cutters over 16.5 lbs (7.5 kg) dry weight (weight w/o fuel) require a double shoulder harness
NOTE
The Barrier Bar is used to restrict rearward movement of the unit. The Barrier Bar is NOT A HANDLE and should
not be gripped when using or carrying the unit.
blade set-up GuIde
Pro Maxi-Cut
Grass/Weed
Blade
Loop Handle, w/or
w/o Barrier Bar
Plastic Shield
Harness
Upper Plate &
Flat Washer
Hex Nut
New Cotter Pin
Rigid Plastic
Tri-Cut
Grass/Weed Blade
U-Handle or Loop Handle
w/Barrier Bar
Plastic Shield
Harness
Upper Plate
& Glide Cup
Hex Nut
New Cotter Pin
Metal Blade
U-Handle or Loop Handle
w/Barrier Bar
Metal Shield
Harness
Upper/Lower
Blade Plates
Hex Nut
New Cotter Pin