Whirlpool AMC 996 Instructions For Use Manual page 13

32602005GB.fm Page 41 Thursday, December 14, 2006 11:24 AM
Replacement of Remote Control Battery and Precautions
1. Gently press down on the battery cover and push in the
direction of the arrow to remove, as shown.
2. Remove the old batteries
3. Replace with two 7# dry cell batteries (AAA 1.5V). Ensure that
"+" and "-" polarity is correctly positioned.
4. Close the battery cover on the remote control.
Precautions
• When replacing the batteries, do not use new batteries with old
batteries, or different types of batteries as this may cause the
remote control to malfunction.
• If you do not expect to use the remote control for some time,
take the batteries out to prevent leakage of battery acid in the
remote control.
• Operate the remote control within effective range.
• Keep the remote control at least 1 meter from any TV set or hi-fi
equipment.
• If the remote control does not work normally, take the batteries
out and reinstall after 30 seconds. If it still does not work install
new batteries.
• To operate the main unit by remote control, point the remote
control at the receiving device on the main unit, to ensure
receiving sensibility.
• To send a message from remote control, the symbol
flash for 1 second. On receipt of the message, the main unit will
emit a beep.
Emergency Operation (on models AMC 996 and AMC 998)
If your remote control is lost or damaged, you can use the 6th Sense
/STOP key, in which case the unit will run in auto mode and you
cannot change the preset temperature and fan speed.
Operate as below:
START: In stop status, press this key to switch the air conditioner
to 6th Sense. Depending on the indoor temperature, the
microcomputer will automatically select the mode
(COOL, HEAT or FAN) for your comfort.
STOP: In on status, press this key to stop the air conditioner.
will
key switch
41