Installation; Dish Setting - Xcruiser XDSR380HD User Manual

w w
HDMI Dolby Digital: Set the
Dolby Digital mode 'On'
or 'Off' in status of HDMI
output.
w w
Dolby Digital Default: Set the
Dolby Digital Default mode
'On' or 'Off'. If you set 'On',
Dolby Audio will play on the
service that support Dolby
Audio.
w w
Sound Mode: Set the audio
mode output among the RCA
jack, optical SPDIF and HDMI
(Stereo/Mono/Left/Right).
w w
Power Saving in Standby Mode:
You can select the Power
Saving in standby Mode.
w w
Audio Sync Delay: To adjust
Audio Sync. You can adjust
from 0ms to 400ms.

3. Installation

3.1 Dish Setting

Select the satellite/antenna
and LNB settings for service
search. The values that are set
in this menu will be available
for selection in other service
searching menus.
w w
Satellite: Select the satellite
which you want to do a search
for.
- Press the LEFT/RIGHT ARROW
button to select the satellite.
- If you press the OK button,
the entire satellite list will be
displayed.
- Select the desired satellite
name to search.
- If the desired satellite name
40
is not listed then select User
Defined.
w w
Frequency: Select the satellite
frequency which you want to
use for checking the signal.
w w
LNB Power: Select the LNB
power on or off.
w w
LNB Type: Select the LNB type.
w w
LNB Frequency: Select the local
oscillator (L.O.). frequency
that is specified for the LNB
used.
- Use the LEFT/RIGHT ARROW
buttons to select the LNB
frequency.
- If the required LNB frequency
is not listed, then enter the
frequency manually using the
NUMERIC buttons.
- When you select Universal
LNB type, both 9750 and
10600 are supported at the
same time. And then the LNB
22KHz setting is disabled.
w w
LNB 22KHz: When you use a
separate coax 22 KHz tone
switch box, make the 22
KHz tone switch enabled or
disabled to select the input
you desire of the tone switch.
w w
DiSEqC Switch: If you use DiSEqC
1.0 or DiSEqC 1.1 switch, select
one of the DiSEqC inputs.
w w
Service Search: Press the OK
button to move to the Search
Menu.