Installation; Dish Setting - Xcruiser XDSR385HD User Manual

w w
HDMI Dolby Digital: Set the
Dolby Digital mode 'On'
or 'Off' in status of HDMI
w w
output.
Dolby Digital Default: Set the
Dolby Digital Default mode
'On' or 'Off'. If you set 'On',
Dolby Audio will play on the
service that support Dolby
w w
Audio.
Sound Mode: Set the audio
mode output among the RCA
jack, optical SPDIF and HDMI
w w
(Stereo/Mono/Left/Right).
Power Saving in Standby Mode:
You can select the Power
w w
Saving in standby Mode.
Audio Sync Delay: To adjust
Audio Sync. You can adjust
from 0ms to 400ms.

3. Installation

3.1 Dish Setting

Select the satellite/antenna
and LNB settings for service
search. The values that are set
in this menu will be available
for selection in other service
w w
searching menus.
Satellite: Select the satellite
which you want to do a
search for.
- Press the LEFT/RIGHT ARROW
button to select the satellite.
- If you press the OK button,
the entire satellite list will be
displayed.
- Select the desired satellite
name to search.
- If the desired satellite name
40
is not listed then select User
w w
Deined.
Frequency: Select the satellite
frequency which you want to
w w
use for checking the signal.
LNB Power: Select the LNB
w w
power on or of.
w w
LNB Type: Select the LNB type.
LNB Frequency: Select the local
oscillator (L.O.). frequency
that is speciied for the LNB
used.
- Use the LEFT/RIGHT ARROW
buttons to select the LNB
frequency.
- If the required LNB frequency
is not listed, then enter the
frequency manually using the
NUMERIC buttons.
XDSR385HD
- When you select Universal
LNB type, both 9750 and
10600 are supported at the
same time. And then the LNB
w w
22KHz setting is disabled.
LNB 22KHz: When you use a
separate coax 22 KHz tone
switch box, make the 22
KHz tone switch enabled or
disabled to select the input
w w
you desire of the tone switch.
DiSEqC Switch: If you use DiSEqC
1.0 or DiSEqC 1.1 switch, select
w w
one of the DiSEqC inputs.
Service Search: Press the OK
button to move to the Search
Menu.