Glacial 8LDIECHK-SC-WFC-VW-SSP User Manual page 8

NOTICE:
When using a 5 gallon rectangular bottle, slide into place as shown in illustration
below.
4. Plug cord into a properly grounded wall outlet.
• Water will be pumped into the hot and cold water reservoirs from the bottle.
5. Turn power switches on back of water cooler to ON, They will glow in ON position.
• The red switch controls the heating of water. If you do not want hot water, leave this switch
OFF
• The blue switch controls the cooling of water. If you do not want cold water, leave this
switch OFF.
Notice:
• It will take up to 3 minutes for the reservoirs to load.
• Diuring the use pump will come no to refill the tanks, This is normal.
Initial Rinsing of Water Lines
This unit has been tested and sanitized prior to packing and shipping. During transit dust and
odors can accumulate in the tank and lines. fill with water. wait for 30 minutes, Dispense
Classes of hot water and 6 glasses of cold water.
Dispense Cold Water
Note: After setup.it will take up to 2 hours to get water to maximum cold temperature.During
this time the compressor may run continuously. This is normal.
1. Position bottle, glass, pitcher or cooking pot securely below cold water tap.
• The right triangle below the cold water control indicates the location of the cold water tap.
• The circular shapes in the drip plate help align the flow of water. This unit dispenses water
at a fast rate. To avoid splashes, hold cup as close to the tap as possible.
2. Depress right control downward to start flow.
3. Release control once desired fill level is achieved.
8