Acer Liquid E3 User Manual page 56

The exposure standard for wireless mobile phones employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6
W/kg. Tests for SAR are conducted using standard operating positions accepted by
the FCC with the phone transmitting at its highest certified power level in all tested
frequency bands.
Although the SAR is determined at the highest certified power level, the actual SAR
level of the phone while operating can be well below the maximum value. This is
because the phone is designed to operate at multiple power levels so as to use only
the poser required to reach the network. In general, the closer you are to a wireless
base station antenna, the lower the power output.
The highest SAR value for US model phones as reported to the FCC when tested for
use at the ear is 0.32 W/kg and when worn on the body, as described in this user
guide, is 0.70 W/kg.
Important: Body-worn measurements differ among phone models, depending
upon available enhancements and FCC requirements.
While there may be differences between the SAR levels of various phones and at
various positions, they all meet the government requirements.
The FCC has granted an Equipment Authorization for this model phone with all
reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on file with the FCC and can be
found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching
for FCC ID: HLZDME380 (for US models).
For body worn operation, this phone has been tested and meets the FCC RF
exposure guidelines for use with accessories that contain no metal and that position
the handset a minimum of 1 cm from the body. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines. If you do not use a body-worn
accessory and are not holding the phone at the ear, position the handset a minimum
of 1 cm from your body when the phone is switched on.
56