Woods FZ23B Operator's Manual page 7

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
(Safety Rules continued from previous page)
 Installation of a grasscatcher assembly will
reduce the stability and maneuverability of the
Mow'n Machine when operating on sloping terrain.
 Do not tow a trailer over 200 lbs. Do not tow a
trailer or add power unit ballast with a combined
weight over 200 lbs. Too much weight can cause
loss of traction or stability on a slope. It can also
reduce parking brake ability. Too much weight will
shorten the hydraulic system life. Never tow a
trailer with a grass collection system attached to
the power unit.
 Watch for hidden hazards on the terrain during
operation.
 Watch for traffic when operating near or cross-
ing roadways.
 Uneven terrain could overturn the machine.
 Do not try to stabilize the machine by putting
your foot on the ground.
 Do not mow near drop-offs, ditches, or embank-
ments. The machine could suddenly roll over if a
wheel goes over the edge or if the edge caves in.
 Stop power unit and equipment immediately
upon striking an obstruction. Turn off engine,
remove key, inspect, and repair any damage before
resuming operation.
 Do not drive or operate mower in tilt-up posi-
tion. Power unit stability is not adequate and result-
ing loads can damage or cause failure of tilt-up
mechanism.
 Never leave a running machine unattended.
 Moving steering levers rapidly from forward to
reverse or reverse to forward could cause loss of
control.
 Do not operate power unit with attachment
removed. Attachment is required for power unit
stability.
 Before attempting to unplug vacuum hoses, dis-
engage PTO, stop power unit, and remove key.
MAINTENANCE
 Before dismounting power unit, follow these
steps: lower attachment to ground, shut off PTO,
set parking brake, shut off engine, position steer-
ing levers to neutral swing-out position, and
remove key.
 When using a sunshade and lifting hood for
maintenance, use caution around pinch points.
MM F-Series (Rev. 8/1/2008)
SAFETY RULES
 Before attempting to unplug vacuum hoses, dis-
engage PTO, stop power unit, and remove key.
 Before performing any service or maintenance,
lower attachment to ground, turn off power unit
engine, remove key, and disconnect battery ground
cable (negative -).
 Before
instructions, securely block up, and check stability.
Secure blocking prevents equipment from drop-
ping due to hydraulic leak down, hydraulic system
failure, or mechanical component failure.
 Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
 Do not work on mower in tilt-up position unless
lock-up mechanism is in good condition. Replace if
damaged.
 Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
 Make sure attachment is properly secured,
adjusted, and in good operating condition.
 Do not put Mow'n Machine into service unless
clutch is working properly. When the engine is at
full throttle, PTO-driven accessories must stop
within five seconds after the PTO switch is turned
t o " O FF. " S e e y o ur d e a l e r f o r r e p l a c e m e n t
clutches.
 Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
 Do not remove radiator cap while engine is hot.
 Do not change engine governor settings or
overspeed engine.
 Frequently check blades. They should be sharp,
free of nicks and cracks, and securely fastened.
 Do not handle blades with bare hands. Careless
or improper handling may result in serious injury.
 Your dealer can supply genuine replacement
blades. Substitute blades may not meet original
equipment specifications and may be dangerous.
working underneath,
(Safety Rules continued on next page)
Safety 7
read manual