Advertisement
10
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Ensure that AERATOR (3) is tightened completely.
Operate HANDLES (1) to allow water flow.
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks.
if necessary.
11
SERVICE
If Faucet Drips Proceed As Follows:
Turn VALVE to OFF position.
If spout drips, operate HANDLES (1) several times from OFF to ON position. Do not force-handles they turn only 90˚.
To Change Direction Of Handle Rotation,
Proceed As Follows:
Turn VALVE to OFF position.
Loosen SET SCREW (2) and pull HANDLE (1) off. Remove
ADAPTER SCREW (4) and pull ADAPTER (3) off VALVE STEM (5).
Turn ADAPTER (3) 90˚ so that flat within ADAPTER (3) catches
a different flat on the VALVE STEM (5).
Replace ADAPTER (3), ADAPTER SCREW (4) and HANDLE (1).
Tighten SET SCREW (2).
To Clean Aerator:
AERATOR (6) may accumulate dirt causing distorted and
reduced water flow. Remove AERATOR (6) and rinse clean.
12
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
Tighten
2
FLAT
5
4
4
WASTE
OUTLET
2
1
4
3
1
5
3
2
"P" TRAP
6
M 9 6 8 8 7 6 R e v. 1 . 2
Advertisement
