Power-On Self-Test; Table 3-4. Post Terminal-Error Beep Codes - HP Omnibook XE4100 Service Manual

Power-On Self-Test

Note
If Quiet Boot is enabled in BIOS Setup (the default setting), press Esc during boot to see POST
messages.
When the notebook boots, its system BIOS runs a series of initialization routines and diagnostic tests
called POST (Power-On Self-Test). The BIOS will not boot the notebook's operating system if the
system memory, CPU, DMA, or interrupt controller fails the POST diagnostic tests. POST indicates
progress by a sequence of codes; if an error occurs, the BIOS displays a message and/or issues a beep
code.
Note that not all POST messages indicate a failure in the notebook—some messages are for
information only. You should not necessarily interpret the failure of one or more POST tests as a
hardware, software, or firmware failure. If POST displays an error message or issues a beep code
indicating an error, confirm the problem using other diagnostic tools.
First, confirm the failure by performing a "clean" boot, as described below. Note that if the notebook
fails to restart with a clean boot, it requires repair.
1. Remove all accessories, including SDRAM modules, port replicator, PC cards, printer, external
monitor, pointing device, and keyboard.
2. Provide "clean" AC power—no auto adapter or unusual AC adapter configuration.
3. Press the reset button to return the notebook to a known state.
4. Press the power button to start the notebook.
If the BIOS detects a terminal error condition, it halts POST after issuing a beep code and/or displaying
a message (see the following table). The beep code indicates the POST routine in which the terminal
error occurred.
Beep Codes*
1
1-2
1-1-1-3
1-1-1-4
1-1-2-1
1-1-2-3
1-1-2-4
1-1-3-1
1-1-3-2
1-1-3-3
1-1-3-4
1-1-4-1
1-1-4-3
1-1-4-4
1-2-1-1
1-2-1-2
1-2-1-3
1-2-1-4
1-2-2-1
1-2-2-3
1-2-2-4
1-2-3-1
1-2-3-3
1-2-4-1
1-3-1-1
3-20 Troubleshooting and Diagnostics

Table 3-4. POST Terminal-Error Beep Codes

POST Description
One short beep before boot.
Search for option ROMs.
Verify Real Mode.
Disable Non-Maskable Interrupt (NMI).
Get CPU type.
Initialize system hardware.
Disable shadow and execute code from ROM.
Initialize chipset with initial POST values.
Set IN POST flag.
Initialize CPU registers.
Enable CPU cache.
Initialize caches to initial POST values.
Initialize I/O component.
Initialize local bus IDE.
Initialize Power Management.
Load alternate registers with initial POST values.
Restore CPU control word during warm boot.
Initialize PCI Bus Mastering devices.
Initialize keyboard controller.
BIOS ROM checksum.
Initialize cache before memory Auto size.
8254 timer initialization.
8237 DMA controller initialization.
Reset Programmable Interrupt Controller.
Test DRAM refresh.
HP Omnibook XE4100/XE4500