Advertisement
Advertisement
Table of Contents
Related Manuals for W Audio EP-300
Summary of Contents for W Audio EP-300
- Page 1 Models: EP - 300 • EP - 500 EP - 800 • EP - 1000 EP - 1300 • EP - 1800 ENGLISH...
-
Page 2: Safety Instructions
WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids. SAFETY INSTRUCTIONS Every person involved with the installation, operation & maintenance of this equipment should: Be competent Follow the instructions of this manual CAUTION! TAKE CARE USING THIS EQUIPMENT! -
Page 3: Operating Determinations
IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! •... - Page 4 Description of the products Front Panel: • EP - 300 • EP - 500 • EP - 800 Front Panel: • EP - 1000 • EP - 1300 • EP - 1800 1, Clip/Limit LED’s - These LED’s flash when the output signal starts distorting. 2, Gain Control: Left Channel - Adjust the desired volume here.
- Page 5 Description of the products Rear Panel: • EP - 300 • EP - 500 • EP - 800 Rear Panel: • EP - 1000 • EP - 1300 • EP - 1800 10, Ground Lift Selector. 11, Bannana/Screw Combination - For connection of the speakers. 12, Fuse Holder - Only replace the fuse when the device is disconnected from the mains.
-
Page 6: Switch Adjustments
Rack Installation The EP Series is built for 19” racks (483mm). The rack you use should be a Double Door Rack where you can open the front and rear panel. When mounting the amplifier into the rack, please make sure that there is enough space around the amplifier. Be careful when mounting the amplifier into the rack. -
Page 7: Operation
Operation After having connected your amplifier to the mains, turn both gain controls counter clockwise to the “min” position. The last product to be switched on is amplifier. The “ON” and “ PROTECT” LED light up now. If it does not, check if the amplifier is connected to the mains correctly. After the turn on delay the speakers are activated (PROTECT-LED is off). - Page 8 CAUTION - DANGER TO LIFE DISCONNECT FROM THE MAINS BEFORE STARTING MAINTENANCE OPERATION Cleaning and Maintenance We recommend a frequent cleaning of the product. Please use a soft lint free and moistened cloth. Never use alcohol or solvents. There are no serviceable parts inside the product except for the fuse. Maintenance and service operations are only to be carried out by authorised dealers.
-
Page 9: Specifications
Specifications... - Page 10 Notes...
- Page 11 Notes...