Professional Power Amplifier HORIZON SERIES Thank you for buying this W Audio product. To take full advantage USER MANUAL of this product, please keep this manual and read the operating instructions carefully. Content Safety instruction……...……………………...1 Connections (Signal output)..……………..6 Main features..……….……………………..2 General operation.
1. Safety Instructions The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated “dangerous voltage “within the product’s enclosure that may be of sufficient magnitude to constitute a risk to persons. The exclamation point, within an equilateral triangle, is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
2.Main features The Horizon Series are professional power amplifiers with advanced switch mode power supply technology for a greater performance. Ideal for mobile performers, DJ, Bar, Meeting Rooms, hotels and restaurants etc. The amplifier features: Soft start up Short circuit protection DC fault protection High temperature protection Overloaded protection...
4.Front panel Horizon 300 Horizon 600 Horizon 800 Horizon 1100 Horizon 1300 For the front panels of the Horizon series amplifier, all the models have the same functions knobs and LED indicators. 1) POWER SWITCH Press this switch to power up the amplifier.
5.Rear Panels: Horizon 300 Horizon 600 Horizon 800 Horizon 1100 Horizon 1300 1) LOW CUT FUCTION 75Hz-24Db/Oct Low cut function (optional) 2) Mode Switch The amplifier is shipped in “Stereo “mode. You can select between Stereo, Bridge, or Parallel mode.
6.Connections (Signal Input) 1)Unbalanced wiring: Fig. 1- Signal input using a 1/4” mono Jack CHA & CHB signal input: Use a mono jack- Tip = signal Sleeve= ground Fig.(1) For balanced wiring, you can also use a 1/4” Stereo 6.3 Jack. 2)CHA &...
7.Connection(Signal output) 1)Stereo Mode Fig. 3 - Signal output using Speakon connector CHA & CHB signal output: 1+、2+ Signal output (+) connect to speaker (+) 1-、2- Signal output (-) connect to speaker (-) Fig.(3) 2)Bridge mode Fig. 4- Signal output using Speakon connector Be sure to set the mode switch on the rear panel to “bridge “(BTL).
8.General Operation 1、Operation procedures: 1) Connect to the matching speakers (dependent on operating mode required) 2) Make sure all the input & output connections are correct and well located. 3) Make sure the mains power supply matches to the power indicated on the amplifier. 4)...
10.Troubleshooting You can check some operation problems as detailed below first before calling your dealer. Problem Problem cause(s) Suggested remedy 1.Power did not turn on 1.Turn on the power. No response 2.Loose connection of the 2.Make sure the power cord is connected firmly to the mains supply when power power cord before turning on the power of amplifier.