Mob Mark; Entering The Mob Mark, Setting Mob As Destination - Furuno GP-7000 Operator's Manual

1. OPERATIONAL OVERVIEW
1.7

MOB Mark

1.7.1

Entering the MOB mark, setting MOB as destination

The MOB (Man Overboard) mark functions to mark man overboard position. You
can inscribe this mark from any mode.
Man
overboad
1. Press and hold down the [MOB/WPT] key immediately for about three
seconds when someone falls onboard, to show the display below.
2. Confirm that YES is selected, and then press the [ENTER] knob to set the
MOB position as the destination. (Choose NO to mark position as a
waypoint.)
If you select the MOB position as the destination, the MOB ALARM window
appears. Push the [ENTER] knob to erase it and then the following message
appear on the display.
When placing the cursor on the MOB mark, distance and bearing to the MOB
position are shown in the MOB data box.
1-6
Range, bearing
Current
position
MAN OVER BOARD!
Set (MOB) as destination?
MOB message window
MOB function is activated
FIX
DST
1.14 nm
MOB
mark
MOB
MOB
162.5 M
0.49 nm
MOB concept
YES NO
MOB ALARM
MOB ALARM window
MOB
33 07. 674N
132 51. 766W
BRG
187 M
MOB data box
MOB information
Distance and range
to MOB position