Horizon Fitness Endurance 4 Owner's Manual page 10

ASSEMBLY STEP 3
ENDURANCE 5 SHoWN
ALL
MODELS
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
10
CONSOLE MAST
CONSOLE CABLES
PRE-INSTALLED BOLTS
AND WASHERS
MAIN FRAME
CRANK
PEDAL ARM
GUIDE RAIL
PEDAL ARM WHEEL
FLAT WASHER (K)
20 mm
Qty: 2
SPRING WASHER (N)
15 mm
Qty: 2
Open hardware for step 3.
A
Carefully pull the console cable through
B
the console mast using the twist tie located
inside the console mast.
Attach console mast to main frame
C
using pre-installed bolts and
washers.
Slide wavy washer (l) over cranK
d
followed by pedal arm as shown. Rest
pedal arm wheel on guide rail.
WAVY WASHER (L)
FLAT WASHER (K)
Attach the pedal arm to the cranK using 1
E
SPRING WASHER (N)
flat washer (K), 1 spring washer (n)
BOLT (M)
and 1 bolt (m).
Repeat steps d–E on the opposite side of the
F
elliptical.
HARDWARE foR STEP 3:
WAVY WASHER (L)
22.5 mm
Qty: 2
BOLT (M)
20 mm
Qty: 2