Table of Contents
Advertisement
KX-TCD952BL(E)14~23
Making Calls
Make sure that the power is ON (p. 11).
1
Press
2
Dial a phone number.
· The dialed number is displayed.
i2345678
· After a few seconds, the display will start
showing the length of the call.
888800 - 00 - 00
3
To hang up, press
handset on the base unit.
· The handset will return to the stand-by
mode.
To dial after confirming the
entered number
1
Enter a phone number.
· The entered number is displayed.
· If you misdial, press
erased from the right.
· To cancel, press
2
Press
· After a few seconds, the display will start
showing the length of the call.
3
To hang up, press
handset on the base unit.
· The handset will return to the stand-by
mode.
14
18/4/00
15:04
Page 14
.
or place the
. Digits are
C
firmly.
C
.
or place the
· If "
" flashes and an alarm tone sounds
after pressing
, move closer to the
base unit. Then try again.
· You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 32).
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
While talking, press
or
desired level.
Ex. LOW is selected.
· After a few seconds, the display will return to
the length of call.
OR
In the stand-by mode, proceed as follows.
1
Press
.
2
until " F6 " is displayed,
Press
or
then press
.
OK
· The current level is displayed.
Ex. LOW is selected.
F6
3
Press
or
to select the desired
level.
4
Press
.
to select the
Advertisement
Table of Contents
