Table of Contents
Advertisement
KX-TCD952BL(E)43~51
Replacing the Batteries
Selecting the battery type
Three Nickel cadmium (Ni-Cd) batteries are included with this unit. Nickel metal hydrid (Ni-MH)
rechargeable batteries can also be used. If you replace the batteries with Ni-MH batteries, you must
set the battery type selection to "1", or the battery strength will not be displayed correctly. The factory
preset is "0" (Ni-Cd).
1
Press
.
2
Press
or
3
Press
.
OK
4
To select Ni-Cd batteries, press
OR
To select Ni-MH batteries, press
5
Press
.
· A confirmation tone sunds and the display will return to the stand-by mode.
· Incorrect battery type selection may shorten battery life.
Battery replacement
If "
" flashes after a few telephone calls even when the handset batteries have been fully
charged, it is time to replace the batteries with new ones. Remember to charge the new batteries
after replacement.
1
Turn the power OFF to prevent memory loss (p. 11).
Remove the cover by sliding while pressing in the
direction of the arrow, then take out the batteries.
2
Replace the batteries with new ones as shown.
· When you finish, close the handset cover
and turn the power ON (p. 11).
3
Be sure to charge the new batteries fully in order to
display the battery icon correctly (p. 10).
Ni-Cd battery: For about 4 hours.
Ni-MH battery: For about 8 hours.
· Discard defective batteries as soon as possible. Defective batteries may leak into the unit.
· Please use only Panasonic P-03H or P-P03S batteries.
· If the rechargeable batteries are not inserted correctly, the handset will not work.
· Nickel metal hydride (Ni-MH) rechargeable batteries (AAA size) are available. Please use only
Panasonic HHR-P03H batteries.
· Please return the rechargeable batteries to your sales shop at the end of their useful life.
18/4/00
15:07
Page 43
until " F33 " is displayed.
0
.
1
.
43
Advertisement
Table of Contents
