Canyon Mountain bike Manual page 53

102 RECOMMENDED TIGHTENING TORQUES
Canyon Frame:
Bottle cage bolts 4.5 Nm
Replaceable derailleur hanger 1.5 Nm
Canyon seat post clamp: 3-5 Nm
If your mountain bike is equipped with a quick-re-
lease lever, read chapter "How to use quick-releases
and thru axles".
Please use the following torques, unless otherwise
indicated by the stem or seat post manufacturer on
the component itself or in the respective assembly
instructions.
Stem:
M5 bolts 4.5-5.5 Nm
M6 bolts 8-9.6 Nm
Adjusting bolt (on top) 0.5-2 Nm
with Ahead stems
Seat post:
Saddle clamp at seat post head
Seat posts with single bolt 20-24 Nm
Seat post with two bolts 6-9 Nm
in line
Seat post with two bolts side-by-side 12-14 Nm
in direction of motion
Seat post Monorail 8 Nm
With steerer tubes made of carbon (black-
i
coloured) tighten the stem with a maxi-
mum torque of 6 Nm.
Tightening torque
All bolted connections on the components
of your Canyon have to be tightened care-
fully and checked regularly to ensure the safe
operation of your bike. This is best done with a
torque wrench that switches off as soon as the
desired torque has been reached. Tighten the
bolts carefully by approaching the maximum per-
missible torque in small steps. Check the secure
seat of the component, as described in the rele-
vant chapters. For parts without torque specifica-
tions, tighten the bolts gradually and check in be-
tween whether the component is already fastened
sufficiently, as described in the relevant chapters.
Do not exceed the maximum torque.
Some components are directly marked
i
with the necessary tightening torque.
Strictly observe the torques given on the labels or
imprints.
Also read the enclosed manuals of the
i
component manufacturers, if necessary,
or visit the Canyon website at www.canyon.com
DISC BRAKES
Shimano
Brake caliper bolt at frame/fork 6-8 Nm
Brake lever clamp bolt 6-8 Nm
Single-bolt clamping
Double-bolt clamping
Sleeve nuts on brake lines near lever 5-7 Nm
and normal brake line on caliper
Barbed fittings for brake lines at 5-7 Nm
brake caliper (disc tube)
Cap bolt 0.3-0.5 Nm 0.6 Nm
Setscrew for bleeder hole 4-6 Nm
Rotor bolts on hub 4 Nm
Brake cable connection to brake lever
Be sure to always follow the operating in-
!
structions of the component manufacturer
when doing any work at the brake system.
RECOMMENDED TIGHTENING TORQUES
Magura Avid Formula
6 Nm 5-7 Nm (RW) 9 Nm
9-10 Nm (FW)
4 Nm
4-5 Nm
(Juicy 5)
2.8-3.4 Nm 2.5 Nm
(Juicy 7/carbon)
4 Nm 5 Nm 5 Nm
alu clamping
7.8 Nm
steel clamping
6 Nm
2.5 Nm
4 Nm 6.2 Nm 5.75 Nm
8 Nm
Disc brake
103