Top Tube - Canyon Mountain bike Manual

22 ASSEMBLY FROM THE BIKEGUARD
CHECkING AND ADjUSTING
Adjust the position of the saddle and handlebars and
check that the handlebars, grips and seat post are
securely fastened, as described in chapter "Adjusting
the Canyon bike to the rider".
Slide your seat post into the seat tube beyond its min-
imum mark and make sure its end reaches beyond the

top tube.

Never ride your Canyon with the minimum
mark of the seat post being visible.
Inflate both tyres to the pressure indicated on the
side of the tyres. Read up on tyres and inner tubes in
chapter "The wheels - tyres, inner tubes and air pres-
sure". Finish the assembly by carrying out thoroughly
the tests described in chapter "Before your first ride".
Take the chainstay protection out of the small part
box and fit it around the chainstay.
After completing the assembly and checks
it is essential to give your Canyon a test
ride in a level, unfrequented area (e.g. in a park-
ing lot)! Wrong assembly or improper adjust-
ments that become apparent in road traffic or
during off-road use can make you lose control of
your Canyon!
Fix the white reflector to the handlebars and the red
reflector to the seat post.
Finish by mounting the spoke reflectors. Make sure
that both reflectors of either wheel are fixed to the
spokes opposite to one another.
Check the reliable fit of all bolts once again
according to the prescribed tightening tor-
ques after 100 to 300 km (60 to 180 miles). For
more information, read chapters "General notes
on care and inspection", "Recommended tightening
torques" and "Service and maintenance schedule".
ASSEMBLY FROM THE BIKEGUARD 23