Gs2 Remote Installation; Packing List; Warnings; Remote Control / Pilot Warnings - Travis Industries Northfield GS2 Owner's Manual

Optional Equipment

GS2 Remote Installation

Packing List


Transmitter

Battery Box

Remote Wall Mount with Attachment Screws and Anchors

Stepper Motor

Torx Wrench

Remote Control DVD

GSR2 IFC

Split-flow Harness (attached to IFC)

System Jumper (attached to IFC)

Battery Box Harness (attached to IFC)

Fan/Light Harness (attached to IFC)

(2) Jumper Wires

(2) 4" Cable Ties

Warnings

Turn off power to the heater (unplug or turn off at the breaker).
Shut off gas at the appliance (or at meter).
HINT:
If using a blower, make sure to have it on hand while installing the remote.

Remote Control / Pilot Warnings

Installing batteries in the battery holder or connecting the appliance to power may
automatically initiate the CPI pilot mode, resulting in a lit pilot flame. Do not place
combustibles in the firebox.
© Travis Industries
KEEP BATTERIES AND COVER
INSTALLED AT ALL TIMES
The remote control system requires the batteries and battery cover to remain in
place at all times. Once the batteries or cover are removed, the system may re-
start in standing pilot mode. If this occurs when the heater is in Remote Mode,
you will not be able to turn the heater off manually from the battery box.
If you need to replace dead batteries, make sure to turn the appliance off before
removing the batteries.
NOTE: If the batteries go dead, the system will operate normally as long as
household power (120v AC) is present.
(for qualified installers only)
4121120
47
100-01315