Table of Contents
Advertisement
4.6.1.2.7
Noise Reduction
4.6.1.2.8
Wide Dynamic Range
4.6.1.2.9
High Resolution Mode
4.6.1.2.10 Image Stabiliser
4.6.2 Context Camera Settings
4.6.2.1
Not available
4.6.3 Low ligh mode at night
4.6.4 IR focus correction
4.6.5 Enable digital zoom
This option selects whether you want to be able to zoom beyond the optical zoom limit and
use digital zoom. The default setting is OFF.
4.6.6 Video Gain
The video gain may be set from 0 to 7 to compensate for losses in long cable runs. Default
is 0.
4.6.7 Video Lift
The high frequency video lift may be set from 0 to 8 to compensate for losses in long cable
runs. Default is 0.
4.7 Keyboard
This sub menu selects options relating to manual control from the joystick keyboard.
4.7.1 Restore Mode (Preset & Tours)
Set this option if you want the dome to revert to a TOUR or PRESET 1 after a specified
period (in seconds) of inactivity.
If the restore mode is not required select OFF
4.7.2 Restore delay (Preset & Tours)
Select restore delay time in seconds. Select 180 seconds to OFF
4.7.3 Joystick/Speed Curve
This option determines the relationship between the joystick offset and the pan/tilt speed
and the setting is a matter of user preference. If linear, the relationship is proportional. If
quasi-linear or non-linear, the movement is slow to start with and increases rapidly as the
joystick is moved more. The default is quasi-linear.
4.7.4 Zoom Ratio
This setting determines how much the pan and tilt slows down as you zoom in and the
setting is a matter of user preference. This slow down helps fine control of the dome position
when zoomed in on a target. The default setting is 16.
Videoswitch
CMOR Dome
Page 17
Vc607a.doc
Advertisement
Table of Contents
