Table of Contents
Advertisement
4.4.4 Install date
The date and time of installation may be set here to provide a record for future service or
maintenance purposes.
4.4.5 Clear Settings
4.4.5.1
Clear all presets
To clear all the presets, enter this menu, use UP to select YES and go LEFT to exit.
4.4.5.2
Clear all tours
To clear all the tours, enter this menu, use UP to select YES and go LEFT to exit.
4.4.5.3
Clear privacy masks
To clear all privacy settings, enter this menu, use UP to select YES and go LEFT to exit.
4.4.5.4
Clear configuration
To clear the menu configuration to the factory defaults, enter this menu, use UP to select
YES and go LEFT to exit.
4.4.5.5
Clear everything
To clear the configuration, presets and tours, enter this menu, use UP to select YES and go
LEFT to exit.
4.4.5.6
Reboot
To restart the dome (equivalent to power cycling), enter this menu, use UP to select YES
and go LEFT to exit.
Note that any unsaved changes to the configuration will be lost when this is done.
4.4.6 Coax Validate Bytes
The dome rejects interference that could be otherwise be decoded as telemetry commands
by checking that a steady stream of valid data is being received. This setting determines
how many good bytes of data have to be received before the telemetry is deemed good.
Increase it to eliminate interference or decrease it if the control is unreliable from a non-
compliant controller. The normal setting is 4.
4.4.7 Language
The language used in the menus may be set here. Currently English and French are
supported.
Videoswitch
CMOR Dome
Page 14
Vc607a.doc
Advertisement
Table of Contents
