Advertisement
• Switch off (or disconnect) the power supply to the appliance.
• Contact CDA Customer Care.
Fault Code
E1
E2
E4
E8
E64
OTHERS
Installation
The appliance can be installed under a worktop or in a wall unit (open
at the rear) with the appropriate dimensions for recessed installation.
Do not use your appliance immediately after moving it from a
cold location, as condensation may cause a malfunction. Wait
approximately 1-2 hours before use.
Centre the oven in the unit. The material of the unit supporting the
appliance must be heat resistant (or covered with a heat resistant
material). For greater stability, attach the oven to the unit with two
screws through the holes provided on the side panels.
If the appliance is to be installed under a worktop, ensure the top rail
has been removed to provide free airflow around the product.
If the oven is to be installed in a tall unit, air gaps of at least 200 cm
must be left for air circulation, as Fig. 12.
26
Fault description
Temperature sensor faulty
Temperature sensor short circuit
Temperature sensor circuit failure
Latch time excessive
Mode selector disconnected
The sum of a combination of the
above codes
2
Advertisement
