Electronic Stability Control (Esc) - Jeep Patriot 2010 Owner's Manual

314 STARTING AND OPERATING
8. Rotate the steering wheel back to center and then an
additional half-turn to the right.
9. Turn the ignition switch to the OFF position and then
back to the ON position. If the sequence was completed
properly, the "ESC Off Indicator Light" will blink several
times to confirm HSA is disabled.
10. Repeat these steps if you want to return this feature
to it's previous setting.

Electronic Stability Control (ESC)

This system enhances directional control and stability of
the vehicle under various driving conditions. ESC cor-
rects for over-steering or under-steering of the vehicle by
applying the brake of the appropriate wheel to assist in
counteracting the over-steering or under-steering condi-
tion. Engine power may also be reduced to help the
vehicle maintain the desired path. ESC uses sensors in
the vehicle to determine the vehicle path intended by the
driver and compares it to the actual path of the vehicle.
When the actual path does not match the intended path,
ESC applies the brake of the appropriate wheel to assist
in counteracting the over-steer or under-steer condition
• Over-steer - when the vehicle is turning more than
appropriate for the steering wheel position.
• Under-steer - when the vehicle is turning less than
appropriate for the steering wheel position.
ESC Off Indicator Light
The "ESC Off Indicator Light" (located in the
instrument cluster) starts to flash as soon as the
tires lose traction and the ESC system becomes
active. The "ESC Off Indicator Light" also
flashes when TCS is active. If the "ESC Off Indicator
Light" begins to flash during acceleration, ease up on the
accelerator and apply as little throttle as possible. Be sure
to adapt your speed and driving to the prevailing road
conditions.