Traction Control System (Tcs); Electronic Roll Mitigation (Erm) - Jeep Patriot 2010 Owner's Manual

310 STARTING AND OPERATING

Traction Control System (TCS)

This system monitors the amount of wheel spin of each of
the driven wheels. If wheel spin is detected, brake
pressure is applied to the slipping wheel(s) and engine
power is reduced to provide enhanced acceleration and
stability. A feature of the TCS system functions similar to
a limited slip differential and controls the wheel spin
across a driven axle. If one wheel on a driven axle is
spinning faster than the other, the system will apply the
brake of the spinning wheel. This will allow more engine
torque to be applied to the wheel that is not spinning.
This feature remains active even if TCS and ESC are in
either the "Partial Off" or "Full Off" modes. Refer to
"Electronic Stability Control (ESC)" in this section of this
manual.

Electronic Roll Mitigation (ERM)

This system anticipates the potential for wheel lift by
monitoring the driver's steering wheel input and the
speed of the vehicle. When ERM determines that the rate
of change of the steering wheel angle and vehicles speed
are sufficient to potentially cause wheel lift, it applies the
brake of the appropriate wheel and may also reduce
engine power to lessen the chance that wheel lift will
occur. ERM will only intervene during very severe or
evasive driving maneuvers.
ERM can only reduce the chance of wheel lift occurring
during severe or evasive driving maneuvers. It can not
prevent wheel lift due to other factors such as road
conditions, leaving the roadway or striking objects or
other vehicles.
NOTE: Anytime the ESC system is in the "Full Off"
mode, ERM is disabled. Refer to "Electronic Stability
Control (ESC)" for a complete explanation of the avail-
able ESC modes.