Related Manuals for JBL Control 10 Series
Summary of Contents for JBL Control 10 Series
-
Page 1: Installation Guide
Control 10 Series Ceiling Loudspeakers Control 12C/T, Control 14C/T, and Control 16C/T Owner’s Manual & Installation Guide Rev A... -
Page 2: Table Of Contents
Seismic Tab Plate (secondary support point) The JBL Control Contractor Control 10 Series ceiling loudspeakers utilize innovative design and materials to provide premium level performance from compact in- ceiling speakers. Available in white or black (-BK). CONTROL 12C/T – A 3” (75 mm) full-range driver to provide high-fidelity full-range sound over an extremely wide coverage area. -
Page 3: Installation Preparations
MTC-26NC MTC-26MR However, when the speaker is being installed into a sheet rock (typically gypsum board) ceiling, JBL’s optional pre-installation brackets can be installed before the sheetrock is installed. The pre-installation bracket provides a bracket to which wiring can USING INCLUDED C-BRACKET WITH be tied behind the sheetrock. - Page 4 Step 1 – Cut the Hole. Cutout the circular hole to the cutout Additional Suspended Ceiling Installation hole size listed above. Pull the wiring through the cutout hole. Information Tile Rails: The tile rails are designed to fit either standard 24-inch wide tiles or 600-mm wide tiles.
- Page 5 Guide to the Pins for Connection -- The removable locking input connector contains 4 terminals, as marked on the con- nector. The pin functions are listed on the label located on the terminal cover plate. From Amplifier or Previous To Subsequent Speaker Speaker(s) CONNECTION...
- Page 6 Step 6 – Tighten the Strain Relief Fitting & Close the Terminal Cover Figure 13: Figure 15: Tighten the Two Horizontal Screws to Slide and Tighten the Tightening Mounting Tabs Strain Relief Fitting. Then Tighten the Two Set Screws into the Backcan.
-
Page 7: Painting The Speaker
CE Declaration of Conformity, con- spirits by rubbing the item with a lightly dampened cloth. Do tact JBL at the address listed at the end of this manual. not, however, use abrasives such as sandpaper or steel wool. Nor should you use gasoline, kerosene, acetone, MEK, paint thinner, harsh detergents or other chemicals. -
Page 8: Maintenance
: 84 dB Coverage : 130˚ Refer servicing to an authorized JBL Service Center. For Max. SPL: 97 dB @ 1m ave., 103 dB peak the name of an authorized Service Center in your area, Nominal Impedance: 8 ohms (in direct/bypass 8Ω setting) contact JBL Professional at the address listed below.