The Traxxas Tq-3 Radio System; Tq-3 Transmitter; Revo Wiring Diagram - Traxxas Revo 3.3 5309 Owner's Manual

The Traxxas TQ-3 Radio System

Your Revo is equipped with the TQ-3 radio system. The TQ-3 is a 3-channel system that provides up to a quarter mile range and control for up to three
servo outputs. Revo is equipped with two high-torque steering servos connected via a "Y" plug adapter (one input, two equal outputs). The TQ-3 works
in conjunction with the OptiDrive ™ Electronic Shift Module to monitor and control the input and output signals for the throttle and shifting servos
(channels). The OptiDrive monitors the voltage of the on-board RX Power Pack. The "Function" LED will flash red if the battery voltage is too low.

TQ-3 Transmitter

Throttle Neutral Adjust
Antenna
Throttle Trim
Steering Trim
Reverse Shift
Forward Shift
Throttle
Trigger
Power Switch Battery Compartment

Revo Wiring Diagram

Charging Jack
(to charger)
Steering Wheel
Antenna
OptiDrive ESM
(Electronic Shift
Module)
Servo Reversing
Switch
Power Indicator
On/Off
Switch RX Power Pack
5-cell NiMH
Battery
Receiver
Battery
Channel 1
Steering Servos
Channel 2
Channel 3
Shifting Servo
(micro servo)
Throttle Servo
To Transmission
(OptiDrive sensor)
The OptiDrive ESM is
designed to adapt and
work with aftermarket
three channel radio
systems (see page 15).
Revo 3.3 • 9