Related Manuals for Traxxas Velineon RUSTLER VXL
Summary of Contents for Traxxas Velineon RUSTLER VXL
- Page 1 owners manual MODEL 37076-4 MODEL 36076-4 MODEL 24076 extreme brushless power system...
- Page 2 POWER SYSTEM read through the Owner’s Manual. This manual contains all the Thank you again for going with Traxxas. We work hard every day ADJUSTING THE necessary set-up and operating procedures that will allow you to...
-
Page 3: Before You Proceed
Traxxas service needs. Maintenance and replacement identified by the icons below. Be sure to read them! To-Win, Rustler, Bandit, Stampede, parts may be purchased directly from Traxxas by phone or online Velineon and ProGraphix An important warning about personal safety or avoiding at Traxxas.com. -
Page 4: Safety Precautions
SAFETY PRECAUTIONS All of us at Traxxas want you to safely enjoy your new model. Operate • Don’t Get Burned: The ESC and motor can become extremely hot your model sensibly and with care, and it will be exciting, safe, and during use, so be careful not to touch them until they cool. - Page 5 LiPos. on the risks associated with LiPo battery use. Traxxas does not • Store and transport your battery pack(s) in a cool dry place.
- Page 6 SAFETY PRECAUTIONS (continued from previous page) • ALWAYS charge batteries in a well-ventilated area. • Allow the battery pack to cool off between runs (before charging). • REMOVE flammable items and combustible materials from the • ALWAYS unplug the charger and disconnect the battery when not charging area.
-
Page 7: Tools, Supplies And Required Equipment
Turnbuckle wrench 4-way wrench model, but are a good idea to include in any RC toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers • Philips screwdriver •... -
Page 8: Front Shock Tower
Steering Block (Rear Camber Link ) EZ-Set ® Button (On/Off Button) Half Shaft Caster Block Rear Battery Compartment Shock Tower Traxxas High- Current Connector Rear Body Mount Turnbuckle Chassis Transmission (Front Camber Link ) Battery Hold-Down Front Brushless Motor Body Mount (Velineon ®... - Page 9 ANATOMY OF THE STAMPEDE VXL Shock (Oil Damper) Steering Block Half Shaft Electronic Speed Control (VXL-3s) Suspension Traxxas High- Arm (Rear) Current Connector Rear Body Mount Chassis Brushless Motor (Velineon ® 3500) EZ-Set Button ® Battery Caster Block (On/Off Button)
- Page 10 ANATOMY OF THE BANDIT VXL Turnbuckle Electronic Speed Battery Steering Block (Rear Camber Link ) Control (VXL-3s) Compartment Half Shaft Caster Block Traxxas High- Battery Hold-Down Current Connector Rear Shock Tower EZ-Set ® Button Chassis (On/Off Button) Rear Body Mount...
-
Page 11: Quick Start: Getting Up To Speed
QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1. - Page 12 INTRODUCTION synch with each other. The VXL-3s electronic speed control is optimized to virtually eliminate cogging. Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals Traxxas Link™ Model Memory. The transmitter’s easy-to-use design Current - Current is a measure of power flow through the...
- Page 13 TRAXXAS TQ RADIO & VELINEON POWER SYSTEM NiMH - Abbreviation for nickel-metal hydride. Rechargeable Thermal Shutdown Protection - Temperature sensing electronics NiMH batteries offer high current handling, and much greater used in the VXL-3s electronic speed control detect overloading To prevent loss of radio range resistance to the “memory”...
- Page 14 Steering CH1 - Channel 1* † Trim *Not used Accessory sensor ports for use with standard voltage/temperature and RPM telemetry sensors (see Traxxas.com and included materials for more information) VXL-3s ELECTRONIC SPEED CONTROL Multi-Function Knob Traxxas High-Current Sensor Expansion Connector (Male)
- Page 15 If you see any other flashing signal from the or 2s LiPo battery equipped with a Traxxas High Current connector is LED, refer to the chart on page required. Traxxas Power Cell iD batteries are strongly recommended for 29 to identify the code.
- Page 16 The Traxxas connector’s gold-plated terminals with a large contact surfaces ensure positive current flow with the least amount of resistance. Secure, long-lasting, and easy to grip, the Traxxas connector is engineered to extract all the power your battery has to give.
- Page 17 Neutral (center) point of the steering channel. an automatic fail-safe system Note: Traxxas Stability Management (TSM) must be completely that does not require user programming. In the event turned off while adjusting steering trim. See page 19 for TSM...
- Page 18 TRAXXAS TQ RADIO & VELINEON POWER SYSTEM 5. Turn the steering wheel on the transmitter back and forth and Higher Speeds Require Greater Distance check for rapid operation of the steering servo. Also, check that The faster you drive your model, the more quickly it will near the Using Reverse: While driving, the steering mechanism is not loose or binding.
- Page 19 To reinstall the antenna: the speed and acceleration that was do not bend or cut the metal tip, engineered into your Traxxas model Stampede VXL and do not bend or cut the white by helping you to maintain control wire at the end of the metal tip.
-
Page 20: Adjusting The Electronic Speed Control
(C). Battery connector: 6. When the LED blinks GREEN ONCE, programming is Traxxas High-Current Verify that Low-Voltage Detection is ACTIVATED: complete. The LED will then shine green or red (depending Connector 1. - Page 21 ADJUSTING THE ELECTRONIC SPEED CONTROL VXL-3s Profile Selection 4. The LED will blink and then turn solid green (Low-Voltage Detection ACTIVE) The speed control is factory set to Profile #1 (100% forward, brakes, and reverse). or red (Low-Voltage Detection DISABLED). The model is ready to drive. Patented Training Mode To disable reverse (Profile #2) or to allow 50% forward and 50% reverse (Profile Note: If you missed the mode you wanted, keep the EZ-Set button pressed...
-
Page 22: Driving Your Model
(mAh) rating of the batteries determines how large their “fuel tank” is. A 3000 mAh • The Traxxas TQi transmitter is not water resistant. Do not subject it to wet battery pack will theoretically run twice as long as a 1500 mAh sport pack. Because of the conditions such as rain. - Page 23 DRIVING YOUR MODEL • Stub axle housing bearings: Remove, clean, and re-oil the bearings. 2. The wheels have small holes molded in to allow air to enter and exit the tire during normal running. Water will enter these holes and get trapped inside the •...
-
Page 24: Basic Tuning Adjustments
Toe-in suspension geometry of the model. The offsets and dimensions designed into the model’s wheels are intentional; therefore, Traxxas For increased stability add one- to two-degrees of toe in to each cannot recommend the use of other non-Traxxas wheels with front wheel. - Page 25 Adjusting the Slipper Clutch Stampede VXL Wheelie Bar Set-up The model is equipped with an The Traxxas wheelie bar comes standard with the Stampede VXL. It is To achieve a good starting adjustable slipper clutch which is available as a bolt-on accessory (Part #3678) for the Rustler VXL and point for the slipper clutch built into the large spur gear.
-
Page 26: Maintaining Your Model
If the bottom of the shock is leaking, then it vibrations may loosen condition of the batteries. is time for a rebuild. The Traxxas rebuild kit for two shocks is hardware over time and require attention. Always 8. Check for any loose screws in the chassis structure part #2362. -
Page 27: Advanced Tuning Adjustments
ADVANCED TUNING ADJUSTMENTS Gearing Compatibility Chart: Gearing LiPo Batteries The chart below shows recommended One of the more significant advantages to your model’s transmission LiPo batteries are intended only for the most advanced users that are gear combination ranges when using a NiMH battery pack to power your model. -
Page 28: Tq I Advanced Tuning Guide
The Multi-Function knob can be set to control Throttle Sensitivity. Restoring Factory Defaults Traxxas Stability Management (TSM) by default, see page 19). Accessing Throttle Sensitivity works the same way as Steering Sensitivity, but the programming menu is done by using the menu and set buttons on applies the effect to the throttle channel. - Page 29 This allows you to fine-tune the servo settings to prevent binding vehicles with a single transmitter via Traxxas Link™ Model Memory. function that returns the throttle caused by the servo moving steering or throttle linkages (in the case...
- Page 30 2. Press and hold MENU. Release when the status LED blinks green. in your collection and simply turn them on and drive. With Traxxas Link 3. Press MENU three times. The status LED will blink green four Model Memory, there is no need remember which transmitter goes times repeatedly.
- Page 31 Transmitter is restored to default Press C onfirm Deletion Delete Model TRAXXAS • 31 Two Blinks Green One Blink Red *Torque Control is a feature designed only for use with the power system in the Traxxas Funny Car Race Replica (Model #6907).
- Page 32 ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
- Page 33 Traxxas Link Real-Time Telemetry For more information The powerful Traxxas Link app (available in the Apple App Store℠ or on When you equip your model about the Traxxas Link Google Play™) gives you complete control over the operation and tuning...
- Page 34 6250 Traxxas Way, McKinney, TX 75070 1-888-TRAXXAS 211130 24076-36076-37076-4-OM-EN-R07...