Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Traxxas Stampede 36054-1
Summary of Contents for Traxxas Stampede 36054-1
- Page 1 MODEL 24054-1 MODELS 36054-1 MODELS 37054-1 owner s manual ’...
- Page 2 CONTROL follow the procedures in this manual. DRIVING YOUR Thank you again for going with Traxxas. We work hard every day MODEL to assure you the highest level of customer satisfaction possible. We truly want you to enjoy your new model!
-
Page 3: Safety Precautions
SAFETY PRECAUTIONS Traxxas materials to prevent serious damage to your model. Failure to follow All of us at Traxxas want you to safely enjoy your new model. Operate 6200 Traxxas Way these instructions will be considered abuse and/or neglect. your model sensibly and with care, and it will be exciting, safe, and fun McKinney, Texas 75070 for you and those around you. - Page 4 Recycling Your Traxxas Power Cell NiMH Battery 14 years of age without the properly installed on every motor to prevent radio interference. Capacitors have Traxxas strongly encourages you to recycle your Power Cell NiMH battery when it been provided with the XL-5. supervision of a responsible has reached the end of its useful life.
- Page 5 Turnbuckle wrench U-joint wrench model, but are a good idea to include in any R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers • Phillips screwdriver...
- Page 6 Front Bumper Pinion Gear Front Shock Tower Slipper Clutch LED Light Shock Pipe Receiver Box (Oil Damper) Antenna Mount Suspension Arm (Rear) Steering Servo Turnbuckle (under Upper Chassis Plate) (Tie Rod) Camber Link Servo Saver (not visible) 6 • TRAXXAS...
- Page 7 Arm (Front) Bulkhead Spur Gear Front Bumper Pinion Gear Steering Servo Front Slipper Clutch Antenna Mount Shock Tower Receiver Box Shock Front Body Mount (Oil Damper) Suspension Arm (Rear) LED Light Pipe Turnbuckle (Tie Rod) Camber Link TRAXXAS • 7...
- Page 8 Pinion Gear Front Shock Tower Spur Gear Slipper Clutch Shock (Oil Damper) Receiver Box Suspension Antenna Mount Arm (Rear) Steering Servo Turnbuckle Rear Shock Tower (under Upper Chassis Plate) LED Light (Tie Rod) Pipe Servo Saver (not visible) 8 • TRAXXAS...
- Page 9 Quick Start pages. 8. Range test the radio system • See page 16 Follow this procedure to make sure your radio system works properly at a distance and that there is no interference from outside sources. TRAXXAS • 9...
- Page 10 TRAXXAS TQ 2.4GHz RADIO SYSTEM INTRODUCTION LiPo - Abbreviation for Lithium Polymer. Rechargeable LiPo battery packs are known for their special chemistry, which Your model includes the TQ 2.4GHz transmitter. When powered Applying the Decals allows extremely high energy density and current handling in a on, the TQ 2.4GHz will automatically locate and lock onto an...
- Page 11 TRAXXAS TQ 2.4GHz RADIO SYSTEM IMPORTANT RADIO SYSTEM PRECAUTIONS Thermal Shutdown Protection - Temperature sensing electronics are used in the ESC to detect overloading and overheating of the • Do not kink the receiver antenna wire. Kinks in the antenna wire To prevent loss of radio range, transistor circuitry.
- Page 12 TRAXXAS TQ 2.4GHz RADIO SYSTEM MODEL WIRING DIAGRAM Your model is equipped with the Traxxas TQ 2.4GHz transmitter. XL-5 Wiring Diagram The transmitter has two channels: Channel one operates the Motor steering, and channel two operates the throttle. The receiver...
-
Page 13: Installing Transmitter Batteries
INSTALLING TRANSMITTER BATTERIES CHARGING THE BATTERY PACK Your TQ 2.4GHz transmitter uses 4 AA batteries. The battery The Traxxas Battery Charger is a fully featured NiMH (Nickle Metal The included charger is compartment is located in the base of the transmitter. - Page 14 Stampede chargers (sold separately) resistance. Secure, long-lasting, and easy to grip, the Traxxas connector is to automatically recognize engineered to extract all the power your battery has to give.
- Page 15 TRAXXAS TQ 2.4GHz RADIO SYSTEM RADIO SYSTEM CONTROLS • Always turn on the transmitter before plugging in the battery. • In order for the transmitter and receiver to bind to one another, Make certain the model’s the receiver in the model must be turned on within 20 seconds receiver antenna is properly of turning on the transmitter.
- Page 16 TRAXXAS TQ 2.4GHz RADIO SYSTEM is wired correctly. Before attempting to reverse the throttle channel 6. When looking down at the 0° 0° using the procedure below, you should first recalibrate the speed model, the front wheels Using Reverse: While driving, control.
- Page 17 TRAXXAS TQ 2.4GHz RADIO SYSTEM to see and control the model. Most drivers will struggle to see and TRANSMITTER LED CODES drive their model at distances farther than a football field (300+ LED Color / Pattern Name Notes Fail-Safe feet). At greater distances, you could lose sight of your model and...
- Page 18 2. Press and hold the EZ-Set button (the LED Low-Voltage Detection Yes (User Enabled) will turn off). After ten seconds, the motor will beep three times and the LED will shine RED. Release the button. 3. Low-Voltage Detection is now DISABLED. 18 • TRAXXAS...
- Page 19 3. When the LED blinks RED TWICE, release the EZ-Set button. Release Solid 4. The LED will blink and then turn solid green (Low-Voltage Detection ACTIVE) or red (Low-Voltage Detection DISABLED). The model is ready to drive. TRAXXAS • 19...
- Page 20 • Fast Blinking Green: The XL-5’s LED will blink fast green if the speed control is not receiving a signal. Make certain the speed control is properly plugged into the receiver and the transmitter is switched on. 20 • TRAXXAS...
- Page 21 The • The Titan 12T motor will benefit from a short break-in period higher voltage potential allows increased speed until the battery to ensure optimum performance and longer motor life. For the begins to become discharged. TRAXXAS • 21...
- Page 22 Your driving habits will determine motor life with a wet motor. Do conditions. not submerge the motor under water. • The Traxxas TQ 2.4GHz transmitter is not water resistant. Do not • Do not gear the motor by temperature when running in wet subject it to wet conditions such as rain.
- Page 23 Pull out all available antenna wiring from the receiver box. 8. Apply a small bead of silicone grease to the foam on the wire clamp (C). 9. Install the wire clamp and tighten the two 2.5x8mm cap screws securely (D). TRAXXAS • 23...
- Page 24 The offsets and dimensions slipper clutch setting is 1/2 For increased stability, add 1°-2° of toe in to each front wheel. Use designed into the model’s wheels are intentional; therefore, Traxxas turn counterclockwise from the turnbuckles to adjust the alignment.
- Page 25 Does Not Fit 7.13 7.78 8.07 8.44 and this gearing is not recommended for off-road or repetitive 6.89 7.53 7.80 8.16 starting and stopping. 6.67 7.28 7.55 7.90 TRAXXAS • 25...
- Page 26 6. Turn off the power to the model followed by the transmitter. The servo horn is now ready to be installed. 7. Be careful not to move the servo shaft when installing the servo horn. Readjust the ESC as described in the “Adjusting the Speed Control” section. 26 • TRAXXAS...
- Page 27 If the bottom of the shock is leaking, then it 8. Check for any loose screws in the chassis structure is time for a rebuild. The Traxxas rebuild kit for two shocks is or suspension. part #2362.
- Page 28 ’ 6200 TRAXXAS WAY, McKINNEY, TEXAS 75070 1-888-TRAXXAS 140929 24054-36054-37054-1-OM-N-EN-R00...
Need help?
Do you have a question about the Stampede 36054-1 and is the answer not in the manual?
Questions and answers