Traxxas E-Maxx 39036-1 Owner's Manual
  1. Manuals
  2. Brands
  3. Traxxas Manuals
  4. Motorized Toy Car
  5. E-Maxx 39036-1
  6. Owner's manual

Traxxas E-Maxx 39036-1 Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODEL 39036-1
owner's manual

Advertisement

Table of Contents
loading

Related Manuals for Traxxas E-Maxx 39036-1

Summary of Contents for Traxxas E-Maxx 39036-1

  • Page 1 MODEL 39036-1 owner’s manual...
  • Page 2 TO SPEED a team of professionals who aim to provide the highest level of Thank you again for going with Traxxas. We work hard every day factory support possible. Traxxas models are about experiencing TRAXXAS TQ to assure you the highest level of customer satisfaction possible.

  • Page 3: Before You Proceed

    Traxxas accompanying materials to prevent serious damage to your 6250 Traxxas Way All of us at Traxxas want you to safely enjoy your new model. Operate model. Failure to follow these instructions will be considered McKinney, Texas 75070 your model sensibly and with care, and it will be exciting, safe, and fun abuse and/or neglect.
  • Page 4 • Always unplug the battery from the electronic speed control when the followed to ensure safe and/or use of LiPo batteries in Traxxas models. If you have questions about model is not in use and when it is being stored or transported.

  • Page 5: Tools, Supplies And Required Equipment

    1.5mm “L” wrench 2.5mm “L” wrench 8mm/5mm wrench Universal wrench include in any R/C toolbox: • Safety glasses • Traxxas Ultra Premium Tire Glue, Part #6468 (CA glue) • Hobby knife • Side cutters and/or needle nose pliers • Philips screwdriver...
  • Page 6 ANATOMY OF THE E-MAXX Half Shaft Steering Servo Hex Hub Slipper Clutch Access Plug Pivot Ball Toe Link Pinion Gear (left side) (Turnbuckle) Axle Carrier Battery Hold-Down Electronic Speed Battery Compartment Toe Link Control (EVX-2) (Turnbuckle) Motors (Titan) Suspension Rear Arm (Front) Body Mount Front Body...

  • Page 7: Quick Start: Getting Up To Speed

    QUICK START: GETTING UP TO SPEED The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom corners of Quick Start pages. The Quick Start Guide is not intended to replace the 1.

  • Page 8: Radio System

    INTRODUCTION Frequency band - The radio frequency used by the transmitter to send signals to your model. This model operates on the 2.4GHz Your model includes the latest Traxxas TQi 2.4GHz transmitter with Applying the Decals direct-sequence spread spectrum. Traxxas Link ™...
  • Page 9 TRAXXAS TQ RADIO SYSTEM Thermal Shutdown Protection - Temperature sensing electronics are used in the ESC to detect overloading and overheating of the To prevent loss of radio range transistor circuitry. If excessive temperature is detected, the unit do not kink or cut the black wire, automatically shuts down to prevent damage to the electronics.
  • Page 10 Port Throttle Trigger To Motor Link Button High-Current Battery Connector Power Switch Battery Compartment Heat Sinks EZ-Set Button ** Accessory sensor port for use with the Telemetry Expander Module (see Traxxas.com and included materials for more information) 10 • E-MAXX...
  • Page 11 INSTALLING TRANSMITTER BATTERIES CHARGING THE BATTERY PACKS Your TQi transmitter uses 4 AA batteries. The battery compartment The Traxxas Battery Charger is a fully featured NiMH (Nickle Metal The included charger is is located in the base of the transmitter.
  • Page 12 “25” - Standard stick packs the power needed to maximize the output of capable of accommodating the EVX-2. The Traxxas connector’s gold-plated terminals with a large either side-by-side racing contact surfaces ensure positive current flow with the least amount of style packs or the more resistance.
  • Page 13 TRAXXAS TQ RADIO SYSTEM RADIO SYSTEM CONTROLS • In order for the transmitter and receiver to bind to one another, the receiver in the model must be turned on within 20 seconds Remember, always turn the of turning on the transmitter. The transmitter LED will flash fast TQi transmitter on first and red indicating a failure to link.
  • Page 14 TRAXXAS TQ RADIO SYSTEM USING THE RADIO SYSTEM Range-Testing the Radio System The TQi Radio System has been pre-adjusted at the factory. The Before each running session with your model, you should range-test Using Reverse: While driving, your radio system to ensure that it operates properly.
  • Page 15 TRAXXAS TQ RADIO SYSTEM 2. Press and hold the receiver’s LINK button as you switch on becomes. Decreased steering sensitivity may be helpful when driving the speed control by pressing the EZ-Set button. Release the on low-traction surfaces, when driving at high speed, or on tracks To prevent loss of radio range LINK button.

  • Page 16: Adjusting The Electronic Speed Control

    ADJUSTING THE ELECTRONIC SPEED CONTROL EVX-2 Wiring Diagram The EVX-2 electronic speed control is factory set and should not require any 4. Release MENU and SET. The transmitter LED will blink red. adjustments. These instructions are provided for your reference. 5.
  • Page 17 ADJUSTING THE ELECTRONIC SPEED CONTROL 4. Return the throttle trigger to neutral. The LED will shine red. 3. When the light blinks red twice, release the 5. Move the throttle trigger forward again to engage reverse (Profile #1). The LED EZ-Set button.

  • Page 18: Driving Your Model

    RUNNING IN WET CONDITIONS Intentionally driving in an abusive and rough manner will only result Your new Traxxas E-Maxx is designed with water-resistant features to in poor performance and broken parts. Take care of your model so protect the electronics in the model (receiver, servos, electronic speed that you can enjoy it for a long time to come.
  • Page 19 Do not use LiPo batteries in wet conditions. submerge the motors under water. • The Traxxas TQi transmitter is not water resistant. Do not subject it to • Do not gear the motors by temperature when running in wet wet conditions such as rain.
  • Page 20 4. Apply small bead of silicone grease • Transmission: Remove, disassemble, (Traxxas part #1647) to the wire clamp. clean, and re-grease the transmission 5. Install the wire clamp and tighten the two components. Use a light coating of 2.8x8mm cap screws securely.

  • Page 21: Tuning Adjustments

    TUNING ADJUSTMENTS SUSPENSION TUNING We recommend using two-hole pistons with a range of oil viscosities from 30W to 50W Adjusting the Pivot Ball Caps For easier access to the (available from your hobby shop). The thinner The pivot ball caps should be adjusted rear-most shock mounting viscosity oils (30W or less) flow with less so that the pivot balls operate freely in...
  • Page 22 (A) to position (B). position of the shocks will allow for lower shock progression and the soft, plush feel that’s characteristic of a Traxxas Maxx Truck. Ride height is not affected by changes in the upper shock mounting position.
  • Page 23 2.5mm hex wrench through the slit in the Traxxas cannot recommend the use of other non-Traxxas wheels dust plug and engage the end of the pivot ball (compressing the with different specifications. The diameter of the wheels is an...
  • Page 24 TUNING ADJUSTMENTS Gearing Compatibility Chart: MOTORS AND GEARING Adjusting Gear Mesh The chart below shows a full range Incorrect gear mesh is the most The Titan ™ 550 Motors on your E-Maxx have been carefully designed of gear combinations. This does NOT common cause of stripped spur to match the needs of the E-Maxx.
  • Page 25 E-Maxx. Optional steering servo horns are sold center line of the chassis (pointing to the rear of the truck). separately for use with non-Traxxas servos. 7. Connect the short steering link from the servo saver to the servo horn.

  • Page 26: Maintaining Your Model

    If the bottom of the shock is leaking, then it 6. Check the tightness of the wheel nuts with a wrench. is time for a rebuild. The Traxxas rebuild kit for two shocks is 7. Check the operation of the radio system, especially the part #2362.

  • Page 27: Tq I Advanced Tuning Guide

    When the Multi-Function knob is have only as much steering throw as they need for the track’s tightest with a single transmitter via Traxxas Link Model Memory. set to throttle trim, the transmitter turn, thus making the model easier to drive throughout the rest of the...
  • Page 28 To delete a model: it possible to pick up any transmitter and any previously bound model in your collection and simply turn them on and drive. With Traxxas Link At some point, you may wish to delete a model you no-longer drive Model Memory, there is no need remember which transmitter goes from the memory.
  • Page 29 3. Press SET. The red LED will blink in single intervals to indicate Steering Sensitivity (Expo) has been selected. Model Locking Press Unlock Traxxas-Link Press 4. Press MENU twice. The red LED will blink three times repeatedly to One Blink Green One Blink Red Four Blinks Green indicate Steering % (Dual-Rate) has been selected.
  • Page 30 ADVANCED TUNING GUIDE Set Multi-Function MENU TREE FORMULAS knob for STEERING Press/hold MENU Press SET Press SET to confirm Press/hold MENU SENSITIVITY (Expo) To select functions and make adjustments to the TQi transmitter without green LED blinks red LED blinks green LED blinks (x8) returns to driving mode referencing the menu tree, turn your transmitter on, find the function in the...
  • Page 31 Link Wireless Module. Real-Time Telemetry Traxxas Link When you equip your model For more information The powerful Traxxas Link App (available in the Apple App Store or on with sensors, the Traxxas Link about the Traxxas Link Google Play ) gives you complete control over the operation and tuning...
  • Page 32 MODEL 39036-1 6250 Traxxas Way, McKinney, Texas 75070 1-888-TRAXXAS 150123 39036-1-OM-N-EN-R00...

Table of Contents