Static Dry System - GE Monogram ZBD1800K Series Technical Service Manual

Static Dry System

The static dry system operates through a vent
located in the control panel. The vent allows hot
air to exit the dishwasher tub and gradually
remove moisture.
Removal
1. Open the dishwasher door.
2. Remove the 6 screws that connect the control
panel cover to the dishwasher door. (See
, step 6.)
Timer
3. Release the door latch and allow the control
panel cover to hang against the dishwasher
door.
4. Remove the static vent channel cover and
assembly as shown below. Inspect the cover
for hard water/lime deposits or debris, and
clean if necessary.
Channel
5. Inspect the o-ring. If the o-ring shows obvious
signs of wear or damage, replace the channel
assembly.
Cover
O-Ring
– 13 –
6. Inspect the gasket on the channel assembly.
If the gasket shows obvious signs of wear or
damage, replace the channel assembly.
Installation
1. Insert the static vent channel through the
static vent door hole.
Hole
2. Install the static vent cover to the static vent
channel, and position the control panel cover
on the dishwasher door.
Gasket
Channel
(Continued next page)