Table of Contents
Advertisement
2.1
Turning the Power On/Off
Turn the [MODE] switch clockwise to turn the power on. The unit starts with the settings used
before it was turned off last time. Note that there is a few seconds delay prior to display of the
picture until the CRT warms up. To turn the power off, turn the switch fully counterclockwise.
2.2
Adjusting Brilliance
Use the [BRILL] key to adjust the brilliance. The selected brilliance level is shown on the display
as below. There are six levels of brilliance including off. Keep the brilliance moderate to extend
the life of the CRT.
BRILL: 0
2.3
Display Mode Selection, Description
2.3.1
Display mode selection
Seven display modes are available and you may select one of them with the [MODE] switch.
MODE Switch
Position
NORM
Provides the normal picture (50 kHz or 200 kHz depending on your system) on
the full screen.
M/Z
Displays the normal display on the right-half of the screen and the marker zoom
display on the left-half.
B/L
Shows the normal picture on the top 2/3 of the screen and the bottom-lock picture
on the bottom 1/3.
B/Z
Shows the bottom zoom display on the left-half of the screen and the normal
display on the right half.
GRAPH
Graphic presentation of navigation data.
DATA
Digital presentation of navigation data.
MENU
Displays the main and system menus.
2. BASIC OPERATION
MODE switch description
Function
2-1
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
