Description Of Timer - Fagor “TOUCH CONTROL” Instruction Manual

DESCRIPTION OF TIMER

Vertical Control and Paella Sensors
On models equipped with a timer, the double hotplate is
equipped with a minutes timer (1 to 99) that automatically
swithes off the heat and sounds an alarm at the end of the
selected time. The double hotplate can operate with or
without programming.
Setting the timer
Touch the sensor +/- sensor for the clock to set
numbers of minutes duration required. To change the
timer rapidly, keep your finger on the +/- sensor.
Operation of timer
With the double hotplate active, if a specific time is
pre-selected, it will act as a timer, switching off the
double hotplate once this time has closed, while giving
an audible signal to advise that the time has expired.
Switch off the warning by operating one of the sensors.
Note
When operating as a timer, the pilot light switches on 00.
When operating as a warning the light does not switch on.
Warning function
When the double hotplate is not switched on, the timer
operates as a warning. If the double hotplate is switched
on after pre-selection has been made, it also acts as a
warning. When the set time has closed it will give a
warning signal which can be switched off by operating
one of the sensors.
Stopping the program
Touch the sensor - until the minutes display reaches 00.
60