KIDDY Cruiser Fix Pro Instruction Manual page 15

Fig. 16
Fig. 17
Fig. 18
Fig. 19
8. To complete installation using the k-fix connectors, press and hold release
button while pressing the booster car seat towards the vehicle seatback. The
cruiserfix pro is installed and ready to secure your child with the vehicle's
three point seatbelt as instructed in section '6.2 Securing your child'.
2. Place the booster car seat on the vehicle
seat. To extend the k-fix connectors, press the
release button in the front under the leg
extension (Fig. 16). The k-fix connectors will
automatically extend from the back of the
booster car seat.
3. Test to confirm the connector hooks are
opened by pushing the release mechanisms
forward (Fig. 17).
The green indicators will not be showing when
the hooks are open and ready for installation.
4. Carefully position the booster car seat to
allow the k-fix connectors to slide into the guide
funnels (if used) and slide onto to the lower
anchors. Press firmly to lock the connectors in
place (Fig. 18).
5. If not using the guide funnels, it may be
necessary to rotate the k-fix connectors and
guide them onto the lower anchors.
6. When properly secured, the k-fix lock
indicators will show green (Fig. 19).
7. Test to confirm the k-fix connectors are
properly secured. Firmly pull the booster car
seat forward and side to side. Check that both
left and right side k-fix indicators show green.
14
ENG