Disassembly Procedure - Mitsubishi Electric Mr.Slim PUHZ-RP200YHA Service Manual

16

DISASSEMBLY PROCEDURE

PUHZ-RP200YHA PUHZ-RP250YHA
PUHZ-RP200YHA
1
OPERATING PROCEDURE
1. Removing the service panel
(1) Remove 8 service panel fixing screws (5o10)
(see photo 1) .
(2) Remove the service panel by sliding it towards you.
w It is the panel to remove when you maintain
the refrigerant circuit, electrical parts, and compressor.
2. Removing the rear panel
(1) Remove 7 rear panel fixing screws (5o10) (see photo 2).
(2) Remove the rear panel by sliding it towards you.
w It is the panel to remove when you maintain the machine
room from the rear side.
3. Removing the front panel
(1) Remove 7 front panel fixing screws (5o10) (see photo 1).
(2) Remove the front panel by sliding it towards you, then upward.
w It is the panel to remove when you maintain the thermistor
and the fan motor.
PUHZ-RP250YHA
1
w When servicing, pay careful attention in removing heavy parts.
w Collect the refrigerant before you service the refrigerant system.
w When brazing, make sure to apply the non-oxidizing braze.
Photo 1
(front)
Front panel
Service panel
Photo 2
(rear)
Rear guard
89
PHOTOS
Front panel
fixing screw
(7pcs)
Service panel
fixing screw
(8pcs)
Rear guard
fixing screw
(7pcs)
Rear panel
fixing screw
(7pcs)
Rear panel