MEMORY/PRESET OPERATION
Memorize the frequently used operation setting by the MEMO button
for convenience.
Start the air conditioner in the operation mode which you want the
remote control to memorize.
Press the button as follows while the air conditioner is in operation.
1
1
1 MEMO button
1
1
Press this button briefly to standby memorizing the setting.
All the icons currently displayed except for the clock display and
mark flashes.
2
2
2 MEMO button
2
2
Press and hold the MEMO button for more than 3 seconds while
the display flashes.
The
mark is indicated and the setting is memorized.
•
If you do not press the MEMO button within 3 seconds or if you
press another button, the MEMORY setting is cancelled.
•
Operation modes which can be memorized with the MEMO button
are MODE, Temperature, FAN, TIMER and Hi POWER.
To operate the air conditioner with the setting memorized by the
MEMO button.
1
1 PRESET button
1
1
1
Press the PRESET button. The setting memorized with the
MEMO button will be indicated and the air conditioner operates
with regards to the setting.
•
The
lamp (green) on the display panel of the indoor unit goes
on, and operation starts after approximately 3 minutes.
•
Initial setting:
MODE
Temperature
EN
01(EN)_1108150401 P08-13
: AUTO
: 22
13
1
2
1
13
05.1.17, 12:20
PRESET
START/STOP
FAN
MODE
AUTO
SWING
ECO
Hi-POWER
TIMER
FIX
MEMO
ON
OFF
SET
CLR
FILTER
RESET
CLOCK CHECK
PRESET
START/STOP
FAN
MODE
AUTO
SWING
ECO
Hi-POWER
TIMER
MEMO
FIX
ON
OFF
SET
CLR
FILTER
RESET
CLOCK CHECK
TOSHIBA 1108150401_EN