BYD e6A Owner's Manual page 83

Right combination switch
cleaning control handle assembly)
Configuration 1:
1
Front wiper
Position 1 (MIST): single wipe mode. The
wiper handle is pushed upward from the
position OFF. By pressing the handle once
and then releasing it, the wiper will wipe once
at low speed and then return to the original
position. By holding the handle for longer (for
over 0.5s), the wiper will start wiping at high
speed until the handle is released.
BYD e6A AUTO Owner's Manual
(
wiper
Position 2 (OFF): stop wiping
Position 3(INT): intermittent gear. The gear is
divided into four grades, whose wiping
frequency is 7s, 5s, 3s and 1s respectively.
2
Turn the switch knob to gear ●, the
a.
wiper will start wiping at low speed
3
every 7 s;
Turn the switch knob to gear ●●, the
b.
4
wiper will start wiping at low speed every
5 s;
5
Turn the switch knob to gear ●●●, the
c.
wiper will start wiping at low speed every
3 s;
Turn the switch knob to gear ●●●●,
d.
the wiper will start wiping at low speed
every 1s.
Position 4 (LO): wiping at low speed.
Position 5 (HI): wiping at high speed.
Front washer
If the wiper handle is pulled back (close to the
side of steering wheel), the washer will just
spray water and will not wipe water when the
acting time is short (within 0.5s); when the
acting time is long, the washer will keep
spraying water and wiping water at low
speed; moreover, it will wipe water
automatically three times and return to the
original position when the handle is released.
Switch 1-65