Panasonic Viera TC-P55VT30 Owner's Manual page 9

Attaching the pedestal to TV
.Assembling the pedestal
• Fix securely with assembly screws (Total 4 screws).
• Tighten screws firmly.
Assembly screws
Accessories
Assembly screws
(8)
THEL090N
size (M5 x 25) (Black)
Poles (2)
.Set-up
• Carry out work on a horizontal and level surface.
• Tighten assembly screws (total 4 screws) loosely at first,
then tighten them firmly to fix securely.
•
»
(")
(")
CD
(J)
(J)
o ....,
roO
(J)
-
o
"'0
.-
0"
::J
Q)
»
(")
(")
CD
(J)
(J)
o ....,
roO
(J)
• (1)
or
®
is printed at the
front of the poles.
Base (1)
Rear side
Bottom view
;;=---Hole for pedestal
installation
llJI---------Pole
Assembly screws
~ ~
I "
~!>
"'.
.
~
,
.
.
,
.
~"'<:~~
"~("'~
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall
hanging bracket or repacking the TV.
CD
Remove the assembly screws (Total 4 screws) from the TV.
®
Pull out the TV from the pedestal.
@
Remove the assembly screws (Total 4 screws) from the pole.
( Warning)
Do not disassemble or modify the pedestal.
• Otherwise the TV may fall over and become damaged, and personal injury may result.
( Caution)
Do not use any pedestal other than that provided with this TV.
• Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
• If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
• If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure.
(above)
• Otherwise the TV and/or pedestal may fall over and become damaged, and personal injury may result.
9