Panasonic Viera TC-P55VT30 Owner's Manual page 52

Settings
«<Items
It~in Descriptiott
t '
• Some menus are grayed out depending on the input signal or condition.
(e.g. "Zoom adjustments" will be grayed out if the aspect is not set to Zoom.)
Aspect Screen format FULL/H-FILLI
Changes the format (aspect ratio).
adjustments JUST/4:3/Z00M Lets you choose the aspect depending on the format of
received signal. (p. 57)
HD size
Size lISize 2 Selects between 95 % (Size 1) or 100 % (Size 2) for the
scanning area with High-definition signal.
Select "Size 1" if noise is generated on the edges of the screen .
• Size 1: Selected item for "HD size". Scanning 95 %
• Size 2: Selected item for "HD size". Scanning 100 %
H size Size 1/Size 2
Adjusts the horizontal display range to reduce noise of both side
edges of an image.
Size 2: Adjusts the image size according to the aspect mode to
reduce noise. (p. 57)
Zoom
adjustments
Adjusts vertical alignment and size when aspect setting is "ZOOM".
PC adjustments Reset to defaults Resets PC adjustments.
Sync
H & V The H and V sync signals are input from the HDND connector. (p. 60)
On green
Uses a synchronized signal on the Video G signal, which is
input from the G connector. (p. 60)
Dot clock Alleviates the problem if a picture appears to be vertically-striped, flickers partially or is blurred.
' ; '
,
Adjusts the vertical position.
Adjusts the horizontal position. :
0
I -,
I
:0
H-position
V-position
Clock phase Alleviates the problem if the whole picture appears to flicker or is blurred.
First adjust the Dot Clock to get the best possible picture, then adjust the clock Phase
so that a clear picture appears.
• It may not be possible to display a clear picture due to poor input signals.
Input
resolution
Switches to wide display.
• VGA (640
x
480 pixels), WVGA (852
x
480 pixels), XGA (1 ,024
x
768 pixels),
WXGA (1 ,280
x
768 pixels)
• Options change depending on signals
H-frequency
V-frequency
Displays the H (Horizontal)N (Vertical) frequencies.
Display range
Horizontal: 15 - 110kHz
Vertical: 48 - 120 Hz
HDMI settings HDMI/DVI RGB
range (HDMI1-4)
Auto/
Prevents the blown out highlights and blocked up shadows when
Standard
a wide-range signal is received. Selects between standard RGB
(16-235)/
range (16-235 bits) or non-compliance (0-255 bits).
Auto: Switches the RGB range (Standard (16-235)/
Nonstandard Nonstandard) depending on the HOMI signal information.
Auto: Switches content type automatically depending on the
HDMI signal information.
Photo: Best setting for JPEG viewing.
Graphics: Best setting for On-Screen display of connected
equipment.
Off/Auto/Photo/
Sets content type to each HOMI input.
Graphics
Contents type
(HDMI1-4)
52