Rear Wheel - Yamaha TW200B Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT

Rear wheel

1
To remove the rear wheel
WARNING
2
To avoid injury, securely support the
vehicle so there is no danger of it
3
falling over.
1. Loosen the axle nut.
4
2. Remove the brake pedal free play
adjusting nut, and then disconnect
5
the brake rod from the brake cam-
shaft lever.
6
3. Turn the drive chain slack adjust-
ing plate on each side of the swin-
garm fully in direction (a).
7
8
9
EAU25080
2
EAU51421
EWA10821
(a)
1
1. Axle nut
2. Brake pedal free play adjusting nut
3. Brake rod
4. Brake camshaft lever
5. Drive chain slack adjusting plate
4. Lift the rear wheel off the ground
according to the procedure on
page 7-37.
5. Remove the axle nut and the
washer.
6. Pull the wheel axle out.
7. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
3
4
To install the rear wheel
5
TIP
Make sure that the drive chain slack ad-
justing plates are installed with the
punched sides facing to the outside
and that the slot in the brake shoe plate
fits over the retainer on the swingarm.
7-39
8. Remove the spacers, the drive
chain slack adjusting plates and
the wheel.
1. Insert the spacers.
2. Install the wheel axle (together
with the left side drive chain slack
adjusting plate) from the left-hand
side.
3. Install the drive chain onto the rear
sprocket.
4. Install the right side drive chain
slack adjusting plate and the
washer.
EAU51431