Replacing The Fuse - Yamaha TW200B Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
tive (-) terminal.
11. Install the seat.
1 To store the battery
1. If the vehicle will not be used for
more than one month, remove the
2
battery, fully charge it, and then
place it in a cool, dry place.
3
NOTICE: When removing the
battery, be sure the key is
turned to "OFF", then discon-
4
nect the negative lead before
disconnecting
5
lead.
[ECA16302]
2. If the battery will be stored for more
6
than two months, check the specif-
ic gravity of the electrolyte at least
once a month and fully charge the
7
battery whenever necessary.
3. Fully charge the battery before in-
8
stallation. NOTICE: When install-
ing the battery, be sure the key
9
is turned to "OFF", then con-
nect the positive lead before
connecting
lead.
[ECA16840]
4. After installation, make sure that
the battery leads are properly con-
nected to the battery terminals and
that the breather hose is properly
routed, in good condition, and not
obstructed.
breather hose is positioned in
such a way that the frame is ex-
posed to electrolyte or gas ex-
pelled from the battery, the
frame could suffer structural
and external damages.
the positive
the negative

Replacing the fuse

The fuse holder is located behind panel
NOTICE: If the
B. (See page 7-9.)
If the fuse is blown, replace it as fol-
lows.
[ECA10601]
1. Fuse
2. Spare fuse
7-33
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
2
1
EAU23503