Installing The Baffl E - Heat & Glo VRT-BZ-N-AUB Owner's Manual

ON BACK OF APPLIANCE:
6. Remove the four screws from the cover plate on rear
of gas stove. Set cover plate aside. Retain screws.
(See Figure 9.8). Attach DV adapter collar in its place.
Install the inner extension collar.
I NNER EXTENSION COLLAR I NNER EXTENSION COLLAR
Figure 9.8
7. Install the cover plate with gasket to the top of gas stove
with screws previously removed (Figure 9.9).
Figure 9.9
42
Figure 9.11
Heat & Glo • VRT-AUB • 2123-980 Rev. K • 5/14
ON TOP OF APPLIANCE:
8. Install the new back panel (without hole) to the rear of
gas stove. Replace the Allen head screws removed in
Step 3 to hold the back panel in place.
9. Install the new top as shown in Figure 9.10.
Figure 9.10
F. Installing the Baffl e
The baffl e is shipped wrapped, inside the fi rebox. Install
the baffl e with the embedded "T" side up, place it on top
of the brackets on the inside of the fi rebox, ensuring back
edge of baffl e makes contact with the back of the fi rebox.