Shutter Adjustment; Installing The Vent Restrictor - Heat & Glo PALOMA-BZ-MOD Owner's Manual

9. Install the cover plate and gasket removed from the
rear of the appliance to the top of the appliance with the
screws previously removed. (Figure 8.12).
10. Install the new solid top.
Figure 8.12
F. Shutter Adjustment
The shutter is located on the underside of the burner, on the
burner neck (see Figure 8.13).
Figure 8.13
Air Shutter Settings
PALOMA-BZ-MOD
PALOMA-BK-MOD
PALOMA-GY MOD
Rear Vent
Top Vent
34 Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 R14 • 11/14
NG LP
1/2 in. 1/2 in.
3/8 in. 1/2 in.
G. Installing the Vent Restrictor
The vent restrictor plate must be installed before installing
the baffle.
On the top of inside firebox for top vent ,on back of firebox
for rear vent, loosen the three screws out about 1/8 in.
Place the vent restrictor plate over the screws and slide into
locking position. Retighten the screws. (See Figure 8.15.)
Rear Vent
Figure 8.15
For vertical venting above 15 ft. a vent restrictor is required.
Top Vent