Connecting The Base; Handset Set-Up - Eircom 8010R User Manual

LU Eircom 8010R_D66.book Page 4 Vendredi, 28. novembre 2008 10:05 10
Y
OUR TELEPHONE

Connecting the base

Before making any connections, please refer to the safety instructions presented at
the beginning of this user guide.
On the back of the base, click in the
telephone jack in its socket (as shown on the
drawing) and connect the other end of the
lead to the wall telephone socket.
Connect the end of the plug lead to the back
of the base station and the plug into the
mains socket.

Handset set-up

Insert the batteries one after the other in
compliance with the battery polarity, as
shown on the label in the handset. Place the
cover back on the handset by pushing
upwards until it is completely closed.
Remove the protective film on the screen,
place the handset on the base to fully charge
the batteries.
The charging icon appears on the screen, it
indicates the charging status. Once the icon
is full, your batteries are charged.
Only use certified rechargeable batteries. For optimal battery charge, leave the
handset on the base for at least 12 hours during initial use. During charging, the
batteries may heat up, this is quite normal and without risk.
Power socket
4
Telephone socket