LU Eircom 8010R_D66.book Page 38 Vendredi, 28. novembre 2008 10:05 10
A
PPENDIX
Care and Maintenance
Use a slightly damp cloth to wipe the base and handset, do not use a dry cloth as this may
cause electrostatic charges.
Problems
Refer to the table presented below in case of an operational malfunction:
Problems
The handset displays "OUT
OF RANGE".
The handset display is blank
The handset does not ring
during an incoming call
No radio link between the
handset and base
The network indicator icon
flashes
You obtain a "busy" dial tone
for each dialled number
Remedies
Make sure that :
•
the plug is properly connected to a power socket.
•
the power connector is properly plugged into the base.
•
your fuse and circuit-breaker are in working order and that the
power socket is powered.
Make sure the batteries are properly installed.
Place the handset on the base and fully charge the batteries.
To increase the life of your batteries, you can perform this operation
about every two months.
If these precautionary measures do not resolve this issue, replace
the batteries. Only use rechargeable batteries.
As time goes by, you may notice a slight decrease in battery
performance. Use your handset until the battery is fully discharged,
and then charge it for at least 12 hours.
Make sure that the telephone is properly connected and that you
have a dial tone.
Make sure your telephone is not set to silent mode (see pargraph
Settings).
Make sure the handset is registered by moving closer to the base, if it
is registered correctly, the handset screen should display its own
handset number.
Otherwise, register the handset to the base. See "Registering a new
handset to a base", page 31.
Make sure no one else is using another handset (if the intrusion mode
is deactived).
Make sure that the dial mode (tone or pulse dialling) is compatible with
your telephone line or your automatic branch exchange.
Make sure your time limit has not run out (if activated).
Make sure you are not on call restriction (if activated)
38
Need help?
Do you have a question about the 8010R and is the answer not in the manual?
Questions and answers