Resetting The Base; De-Registering A Handset - Eircom 8010R User Manual

LU Eircom 8010R_D66.book Page 34 Vendredi, 28. novembre 2008 10:05 10
S
ETTINGS

Resetting the base

When you reset your base, all the base
parameters are reset to their initial values
(factory settings).
On the navigator key
until the SETTINGS screen is displayed,
press OK to confirm.
Select ADVANCED SET. using
Press Valid. .
Select SET BASE. Press Valid.
Select RESET BASE using
Valid. .
A confirmation screen will prompt you to
confirm your request:
• To reset the base, press Yes
• If you do not wish to reset the base,
press No .
Enter the base code. Press Valid.
RE-INIT. IN PROCESS
displayed on the screen.
To exit the menu, press the red key
When resetting the base, the base
code becomes 0000 again.

De-registering a handset

This function enables you to de-register a
handset from your base. This may be
necessary if you have lost a handset or if you
already have 6 handsets registered to the
same base.
, press or
On the navigator key
until the SETTINGS screen is displayed,
or . press OK to confirm.
Select ADVANCED SET. using
Press Valid.
.
or . Press Select SET BASE. Press Valid.
Select DELETE HANDSET using
Press Valid.
Select the handset you wish to unregister in
.
the list by pressing
Valid.
A screen prompts you to confirm the
. The
message is unregistration. Press Yes
the handset.
. To exit the menu, press the red key
34
, press
or
.
.
or
.
or . Press
.
to unregister
or
.
.
.