Installing The Stack Bracket Kit - GE GFDN110 Owner's Manual

INSTALLING THE STACK BRACKET KIT

1. Remove the Dryer Leveling
A. Carefully lay the dryer on its side.
B. Use an open-end wrench or pliers to
Back out and remove
all 4 leveling legs
2. Install Rubber Pads to Dryer
Locate the 4 rubber pads in the parts
package. Remove the adhesive backing
and firmly place over on the bracket
where you removed the leveling legs.
3. Install Bracket to Dryer
A. Align the holes in the left bracket
B. Repeat the above step with the right
C. Set the dryer upright.
NOTE: Make sure to set the dryer on
Legs
Use the packing material so you
don't scratch the finish on the dryer.
remove the dryer leveling legs.
Base
with the holes in the bottom left
corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1
tapping screws.
bracket on the bottom right corner
of the dryer.
www.GEAppliances.ca
a piece of packing material so the
brackets that are attached to the
bottom of the dryer do not damage
the floor.
21