Traeger BBQ 075 Owner's Manual page 2

Congratulations on your purchase of this TRAEGER Pellet Grill, Model BBQ
075, Texas. With proper set-up, operation and maintenance, this grill will provide
you with years of cooking enjoyment.
Your new grill comes almost completely assembled. You will need to complete
the assembly which includes:
1) Mounting the pellet hopper/firepot (23) onto the main barbecue body (2)
2) Mounting the smoke stack (1) onto the main barbecue body (2)
3) Positioning the U-shaped firepot cover (5) over the firepot (10), and setting
the angled drip pan (6) in place.
4) Installing the rear wheels to the barbecue body (27)
5) Installing the Viper casters to the front legs (28)
6) Hanging the grease bucket (22) on the grease drain tube hook (16) located
on the grease drain tube.
NOTE: NUMERALS FOLLOWING PART NAMES THROUGHOUT THIS
MANUAL REFER TO THE COMPONENT DIAGRAM ON THE PREVIOUS
PAGE.
When you un-box your grill, make sure you have, and can identify all of the
following parts:
(1) Bag of nuts, washers, and bolts. These are for mounting
the pellet hopper/firepot, smokestack and handle to the
barbecue.
(1) Main barbecue body (2)
(1) Pellet hopper/firepot (23)
(2) Wheels (27)
(2) Viper Casters (28)
(1) Porcelain coated cooking grill (4). Remove for assembly
(1) U-shaped firepot cover (5). Remove from grill for assembly
(1) Angled drip pan (6). Remove from grill for assembly
(1) Grease catch bucket (22)
(1) Smokestack (1)
Follow these step by step instructions and you'll be cookin' in no time!
7/16" open-end wrench or an adjustable crescent wrench.
A Phillips screwdriver or screw gun with a Phillips screw driver bit
¼ inch Allen wrench
INTRODUCTION
TOOLS REQUIRED FOR ASSEMBLY