Rf Exposures - FALCOM TANGO55 User Manual

TANGO55/i & TANGO56/i User's Manual

9 RF EXPOSURES

This device contains 850/1800/1900 MHz or 900/1800/1900 MHz GSM/GPRS functions
that are operational in these frequencies respectively.
The following statements according to the FCCs are applied for the TANGO56, only.
However, the TANGO56 terminal contains 1800 MHz GSM functions that are not
operational (must not be used) in U.S. Territories. This filing is only applicable for
850MHz GSM/1900 MHz PCS operations, whereby only these frequencies (850MHz
GSM/1900 MHz PCS) are possible to be used in U.S. Territories.
The external antennas used for this mobile transmitter must provide a separation
distance of at least 20 cm from all persons and must not be co-located or operating
in conjunction with any other antenna or transmitter.
Statement according to FCC part 15.19:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
()1 this device may not cause harmful interference, and
()2 this
interference that may cause undesired operation.
Statement according to FCC part 15.105:
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
This confidential document is a property of FALCOM and may not be copied or circulated without previous permission.
device must accept any interference received,
Version 1.05
including
Page 46 of 46